Materials:
1x Stalogy Pen (BP or MP it doesn't matter)
1x Bic Roundstic
1x Pentel RSVP (Cap and Grip)
1x Pentel HGG/HGR (Grip and Tip)
Steps:
1. Take your Stalogy, disassemble it, and cut off this much from the clicker side. (2 cm ish depending on how long u wanna make your bt mx)
2. Take your Bic Roundstic, remove the ink tube, and cut off this much. (3.5 cm not counting the ink tube holder)
3. Place your HGG/HGR tip onto the front of the Bic Roundstic. If you are using HGG, the tip should screw onto the front of the Bic without any problems. If you are using HGR you will need to use tape to hold the tip to the front of the Bic. (If you don't want to use tape you could experiment with a G3 rubber to hold the tip down)
4. Prepare your RSVP cap like usual.
5. Assemble all the parts. The Bic portion will go onto the side with the threads and the cap will go on the cut side of the BT. (You may need a small portion of tape.)
6. Finished!
Notes: Honestly, if you don't like spinning MX, don't make this mod. You'll hate yourself for cutting up a BT and making a mod that spins like MX. On the bright side, if you think MX is cool and you wanna spice it up a bit, this is a great way to do that, especially if you like rubber barrels. Another good thing about this mod is that you can make an extended stalogy with the bt internals, so in my opinion, deciding to make this mod results in a win-win situation. Lastly, this same exact concept can be applied to the Kacogreen barrels, so if you want to make a KGMX, go for it :)
