Stats:
- 20cm
- 15.8 g
The materials you will need are as follows:
- 1* Pilot G3
- 1* Pilot Juice Up
- 1* Uniball Signo DX
- 1* Uniball Lakubo
- 1* Frixion Colors
- 1* Jimnock/Hyperjell/Jimnie
- 2* Papermate Profile / Dong-a Anyball
- Electrical Tape
The steps to construct the mod are as follows:
Remove the tip, inktube, and backplug of the G3. Do not clean the front.
Remove the plastic piece from your Frixion Colors cap.
Cut one of your Anyball/Profile grips so that you have 7 sections remaining (rings 5-11)
Cut your Signo DX grip on the 5th dimple.
Place your Signo DX tip into the Frixion Colors cap followed by your Jimnock/Jimnie/Hyperjell
Slide your cut DX grip over the G3, stopping where the end of the G3 grip is.
The tipstack is Lakubo backplug > Juice Up tip.
Screw the tip on and fill the gap in with electrical tape.
Slide your cut 7 sections of Anyball onto the cap, and slide the
remaining whole Anyball over the front of the G3. You're finished now, congrats.
Due to the construction of this G3, it doesn't take very long to make while at the same time offering a wide range of color customization options. I would say this G3 spins most similarly to Itezy-3 with the benefit of not being horribly unbalanced. Personally, I am not that big of a fan of G3 mods that are above 15 grams, especially ones with a dense feeling like this, so this mod, unfortunately, isn't for me. However, if heavier G3 mods are what you like, then I would highly recommend this mod.
Original Tutorial links can be found here.
No comments:
Post a Comment